| 1. | Standard specification for welded , unannealed austenitic stainless steel tubular products
焊接未退火的奥氏体不锈钢管形制品标准规范
|
| 2. | High deposit temperature leads to transmission falling of the unannealed films . but the average transmission of sample deposited at 500 is higher than that at 450
未经退火的薄膜透过率随沉积温度升高而呈现下降的趋势，但500样品比450的平均透过率高。
|
| 3. | The nano - crystals of si are found embedded in the amorphous matrix in the unannealed sample . the crystallinity of the films is increased with raising deposit temperature
研究发现，未经退火处理的薄膜是纳米硅品粒镶嵌于非晶介质中，并与氧化硅晶粒形成复合的特殊结构。
|
| 4. | After dealing with post heating at the same deposit temperature , the average of transmission and reflectance of the films are smaller than unannealed ones but eopt is enlarged
相同沉积温度下制备的薄膜样品经过不同退火温度和退火时间处理后，薄膜的平均透过率和平均反射率都比退火前下降，光学能隙变大。
|
| 5. | Then , by annealing , the si / sic / sich nano - composite films are prepared . the influence of the post - heating on the microstructure of the films has systematically been studied by the means of the measurements of hrem . the nano - crystals are found embedded in the amorphous matrix in the unannealed sample and the crystallinity is not high
以硅烷和乙烯为原料气采用常压化学气相沉积制备得到si / sic复合薄膜，并使用退火处理方法对该薄膜进行后处理，最终得到si / sic / slo ：纳米镶嵌复合薄膜。
|
您当前位置：